Reply to thread

Message: [QUOTE="Shplad, post: 229622, member: 22044"] The foam on the new solenoid is not sticky? All gears are in their proper place on that side of the assembly? On that series, that error is a jam/feed error. Typical troubleshooting procedures for that include: [LIST=1] [*][B]Turn off the printer completely:[/B] Unplug the power cord from the wall outlet and wait a minute. [*][B]Check for paper jams:[/B] [LIST] [*]Carefully remove any jammed paper from the printer's input tray, output tray, and any other accessible areas. [*]Inspect the registration assembly area for any debris or obstructions. [/LIST] [*][B]Reseat the ITB (Image Transfer Belt):[/B] [LIST] [*]Locate the ITB within the printer. [*]Carefully remove the ITB and then reinsert it, ensuring it's properly seated. [/LIST] [/LIST] If all that fails, maybe one of the paper jam sensors has gone bad. [/QUOTE]