Hp pro200 laserjet


Joined
Oct 16, 2015
Messages
8
sir,
i have one hp pro 200 laser jet printer..this always show display error message for REAR DOOR OPEN....HOW TO CLEAR THIS ISSUE PLS HELP ME..
 
Ad

Advertisements

Joined
Dec 7, 2016
Messages
1,001
Rear Door has micro switch, which you might slightly re-position to ensure switch closure.
Look for mounting screws that hold switch in place. Loosen screws and re-position.

Alternative:

See if you can activate switch with your fingers. See if error message disappears.
Switch may be defective as well.
 
Joined
Oct 16, 2015
Messages
8
Rear Door has micro switch, which you might slightly re-position to ensure switch closure.
Look for mounting screws that hold switch in place. Loosen screws and re-position.

Alternative:

See if you can activate switch with your fingers. See if error message disappears.
Switch may be defective as well.
THANKS FOR ADVICE....Sir. i cant find micro switch.kindly give location for switch pls...find one door closing side sensor...laserjet pro200 colour m251n
 
Last edited:
Joined
Dec 7, 2016
Messages
1,001
Error message "rear door open" on the printer.

Do a power reset to see if that solves problem.
With printer turned on, disconnect the power cable from the rear printer.
Now disconnect the power cable from the wall outlet.
Wait a minute and reconnect the power cable. Restore power. Is error message gone?
Be sure to use wall outlet. Don't use a power hub or a surge protector.

If you Flip the back door down, you will see two plastic pieces near top.
Are they perhaps broken off. With door closed, tab on the left side goes into a hole to activate door sensor to indicate the door is closed. Sensor switch could also be defective. Replace switch if plastic pieces intact (not broken).

Advise
 
Joined
Oct 16, 2015
Messages
8
Error message "rear door open" on the printer.

Do a power reset to see if that solves problem.
With printer turned on, disconnect the power cable from the rear printer.
Now disconnect the power cable from the wall outlet.
Wait a minute and reconnect the power cable. Restore power. Is error message gone?
Be sure to use wall outlet. Don't use a power hub or a surge protector.

If you Flip the back door down, you will see two plastic pieces near top.
Are they perhaps broken off. With door closed, tab on the left side goes into a hole to activate door sensor to indicate the door is closed. Sensor switch could also be defective. Replace switch if plastic pieces intact (not broken).

Advise
 
Ad

Advertisements

Joined
Oct 16, 2015
Messages
8
Error message "rear door open" on the printer.

Do a power reset to see if that solves problem.
With printer turned on, disconnect the power cable from the rear printer.
Now disconnect the power cable from the wall outlet.
Wait a minute and reconnect the power cable. Restore power. Is error message gone?
Be sure to use wall outlet. Don't use a power hub or a surge protector.

If you Flip the back door down, you will see two plastic pieces near top.
Are they perhaps broken off. With door closed, tab on the left side goes into a hole to activate door sensor to indicate the door is closed. Sensor switch could also be defective. Replace switch if plastic pieces intact (not broken).

Advise
yes sir .....rear door problem only...rear door sensor closer liver not working properly...it reseated after rear door open message did not come and working good....thanks for your cooperation...THANK YOU...
 
Ad

Advertisements


Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments. After that, you can post your question and our members will help you out.

Ask a Question

Top