Forums
New posts
Search forums
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Printer Forums
Printer Discussion
Hp pro200 laserjet
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
[QUOTE="ruffin, post: 211205, member: 9684"] Error message "rear door open" on the printer. Do a power reset to see if that solves problem. With printer turned on, disconnect the power cable from the rear printer. Now disconnect the power cable from the wall outlet. Wait a minute and reconnect the power cable. Restore power. Is error message gone? Be sure to use wall outlet. Don't use a power hub or a surge protector. If you Flip the back door down, you will see two plastic pieces near top. Are they perhaps broken off. With door closed, tab on the left side goes into a hole to activate door sensor to indicate the door is closed. Sensor switch could also be defective. Replace switch if plastic pieces intact (not broken). Advise [/QUOTE]
Verification
Post reply
Forums
Printer Forums
Printer Discussion
Hp pro200 laserjet
Top