Forums
New posts
Search forums
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Manufacturers
Minolta
Konica Minolta 2500W OPC fuse Blowing??
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
[QUOTE="WarrenG, post: 194893, member: 1349"] Hi everyone, This is my first post on the forum. I have a Konica Minolta 2500W that seems to have a problem with the OPC drum fuse blowing and I don't have any idea why? The drum showed that it had expired and so I replaced the fuse with a compatible F80mA 250V fuse and the drum was reset and has worked fine for a couple of months. :) I recently started to notice that lines were appearing on my print copies and checked the fuse. The fuse had blown. So I replaced it again but It then blew again. :( Thinking that the drum must be completely shot (even though I managed to get a print total of only 10,000 odd) I purchased a brand new one and replaced it. To my horror the print quality was just the same and when I checked the new fuse in the new drum it had also blown? :eek: I have had no error messages and I can print out but the quality is really bad. I am assuming that this is due to the drum no functioning correctly? :confused: The printer has usually been fine up until this point and the quality has been really good. If anyone could point me in the right direction I would be really greatful because the toners are 75-100% full still and I have just paid out on a brand new drum. Warren [/QUOTE]
Verification
Post reply
Forums
Manufacturers
Minolta
Konica Minolta 2500W OPC fuse Blowing??
Top