no power to printer head or lcd

Joined
Feb 22, 2017
Messages
2
mimaki nv3 75sp printer . I have just purchased this and it started up fine this morning then I turned it off and a few hours later switched it on and the front switch green light works but nothing else . I have checked the fuse and the power chord seems connected fine. anyone know which part to disconnect or replace to find the fault? I have little knowledge.thanks.
 
Joined
Feb 22, 2017
Messages
2
0 response , there must be a printer engineer out there?
iv looked at forum threads and they say it could be a fuse inside? I wouldn't know where to look.
iv looked inside and its just wires and circuit boards .
 

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments. After that, you can post your question and our members will help you out.

Ask a Question

Top