Forums
New posts
Search forums
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Printer Forums
Printer Discussion
SC P5000 prints nicely for the first two inches down, then quits
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
[QUOTE="perkin-warbeck, post: 214939, member: 13461"] There were three low ink lights: LC, VM, and C. No other warning lights or symbols were flashing. Today I printed the "color layer" on a BLANK sheet of Arches paper. The print was perfect and the paper ejected normally when the print was done. This means the paper is not the problem. It's what's ON the paper. I called Epson support. The only advice from them was to print from Photoshop rather than Lightroom. So I printed from Photoshop over cyanotype and got the same partial print followed by a Paper Eject error. This means the application is not the problem. It's what's ON the paper! What is it about printing on paper that has some color on it that would cause A P5000 to give up in such a strange way? Surely the P5000 doesn't demand a clean white sheet of paper. [/QUOTE]
Verification
Post reply
Forums
Printer Forums
Printer Discussion
SC P5000 prints nicely for the first two inches down, then quits
Top