Just bought a used 5540C SE with finisher. $500/400k copies
I know it's an old machine, but it still has some more copies to give.
I'm getting a C390 error. Call service.
Pulled the EPU tray and checked the connections I could see. Cleaned the sensor under cyan and reinstalled.
Powered on and then got C3A0 error.
Did same procedure with magenta. And the rest at the same time Powered on again and was back at C390.
The machine has not been used for 4 years but had no errors when it was shut off.
It was transported in a trailer but was properly secured.
Of course, there was vibrations and some bumps when loading and unloading. it's one heavy mf.
Any ideas on where to check?
I would guess there is just something that has come loose somewhere or toner that has ended up on some sensor maybe.
I know it's an old machine, but it still has some more copies to give.
I'm getting a C390 error. Call service.
Pulled the EPU tray and checked the connections I could see. Cleaned the sensor under cyan and reinstalled.
Powered on and then got C3A0 error.
Did same procedure with magenta. And the rest at the same time Powered on again and was back at C390.
The machine has not been used for 4 years but had no errors when it was shut off.
It was transported in a trailer but was properly secured.
Of course, there was vibrations and some bumps when loading and unloading. it's one heavy mf.
Any ideas on where to check?
I would guess there is just something that has come loose somewhere or toner that has ended up on some sensor maybe.