Forums
New posts
Search forums
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Printer Forums
Printer Repair
Total DA Mistake but is it fixable?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
[QUOTE="foamnone, post: 218299, member: 16275"] I purchased a used Konica Minolta bizhub C754e (with 100k clicks) It uses a 20A plug (3 wires: black, white, green) I plugged the printer into a 4 prong outlet. 220 v was sent to the printer. (white & black were hot) The power switch on the unit only breaks the hot wire (black). So, 110v traveled the white wire directly into the machine. Now, nothing happens when wired correctly. Nothing! I understand this is such a monumental mistake that No manufacture could make a unit Idiot proof. Trust me, I am nauseous just thinking about it. Now, for my questions: 1. Where do I start to figure out if the printer is fixable? 2. What would you test/replace to start diagnosing? It wouldn't be so bad but I moved this unit upstairs in a residents and that is where my comedy of errors will end for now. [/QUOTE]
Verification
Post reply
Forums
Printer Forums
Printer Repair
Total DA Mistake but is it fixable?
Top