Forums
New posts
Search forums
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Printer Forums
Ink Cartridges, Toner and Refills
Bad quality after a toner refill
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
[QUOTE="Doctorslo, post: 205602, member: 6149"] I have disassembled the old cartridge for the first time, so I wanted to make sure that I will be able to successfully assemble/disassemble it before buying a toner powder. There were two places in the cartridge where the powder was, so I assumed that one place is for the "waste" powder. I refilled the cartridge with that "waste" powder ... it looked the same as the one that it's stored on the other place (for printing). I didn't disassembled the part where you add a new powder in, because there might be still some inside. After reassembly, the printing was not so good. The page is not fully printed (see the picture). And there are also some horizontal lines on it (that happened also before I disassembled it). What could be wrong? Is it possible that here is not enough toner? Or I didn't cleaned it up correctly? I did it like this guy: [MEDIA=youtube]zI7JYT2_T0k[/MEDIA] ... until 4:10 (I skipped to the refill + assembly after that). On the picture, left page is the one with that cartridge I disassembled, the right is as it should be. [IMG]http://shrani.si/f/42/u5/1xnu5SPS/img20141122170026.jpg[/IMG] [/QUOTE]
Verification
Post reply
Forums
Printer Forums
Ink Cartridges, Toner and Refills
Bad quality after a toner refill
Top