Forums
New posts
Search forums
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Manufacturers
Brother
Brother eject / exit rollers reversing direction causing jam
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
[QUOTE="lgmccoy1, post: 212753, member: 12042"] My Brother MFC-8710DW Laser printer keeps jamming everytime I try to print. It happens when it reaches the exit rollers and just curls/wrinkles up. I even disassembled the printer to clean the rollers. At first it started working again but began to jam again in the middle of a duplexing print job. At this point I noticed that the eject rollers had reversed direction and this was causing the jam whenever the paper reached the rollers for them to pull the paper through but instead because they were going in wrong direction a jam occurs. If I leave the back cover open I can print everytime and just catch the paper as it comes out the back. Is there a duplex sensor somewhere that could be stuck and it thinks its in duplex mode? Any help is appreciated? [/QUOTE]
Verification
Post reply
Forums
Manufacturers
Brother
Brother eject / exit rollers reversing direction causing jam
Top