Reply to thread

Message: [QUOTE="Andrew Aitken, post: 212316, member: 11755"] Hello I have a Canon MG 2950 printer and I am trying to increase part of a scanned document. The plans are from a construction kit and are smaller than the kit itself. I have enlarged a box around the part of the plans I wish to enlarge and then increased the % in the box to the size i wish to increase the plans to. in this case the increase is 185% The trouble is that the printer is increasing the whole scanned area by 185% not the part of the plans I have highlighted in the box. It must be something simple I'm doing wrong but I wonder if anyone can give some advice. Thankyou [/QUOTE]