Canon MG2950 Scaling up plans

Joined
Feb 13, 2018
Messages
1
Hello
I have a Canon MG 2950 printer and I am trying to increase part of a scanned document. The plans are from a construction kit and are smaller than the kit itself.
I have enlarged a box around the part of the plans I wish to enlarge and then increased the % in the box to the size i wish to increase the plans to. in this case the increase is 185%
The trouble is that the printer is increasing the whole scanned area by 185% not the part of the plans I have highlighted in the box. It must be something simple I'm doing wrong but I wonder if anyone can give some advice.
Thankyou
 

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments. After that, you can post your question and our members will help you out.

Ask a Question

Top