Forums
New posts
Search forums
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Printer Forums
Printer Repair
EcoTank ET2750 Fuses F301 and F302
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
[QUOTE="xelaris, post: 221107, member: 19090"] When bought this ET2750 (as spare repair) I've noticed there was a short in the printhead's cable - the cable was visibly burnt so I replaced it and bought a new printhead. Then I shorted the F301 fuse on the board. Now, after reconnecting everything...the printer turn on and seems to be working perfectly except for one thing: it "prints" blank pages - and even after printhead cleaning there is no ink passing through the printhead. This might indicate a fuse on the board is preventing power to reach the printhead?Since I bridged the F301 fuse I wonder if the culprit is the F302 fuse. The second "fuse" F302 is visibly completely different from the F301 in that it seems is made of 2 small copper rectangles - shall I bridge them? Is that actually a fuse? (never seen anything like - I'm a beginner) - if not what F302 means? the two (F301 and F302) are side by side on the logic board and can't see anything else around the F302 label except for these 2 small copper rectangles. Any help appreciated. [/QUOTE]
Verification
Post reply
Forums
Printer Forums
Printer Repair
EcoTank ET2750 Fuses F301 and F302
Top