Forums
New posts
Search forums
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Printer Forums
Printer Repair
How to fix Samsung Express C1860FW Laser Printer stuck on LOGO?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
[QUOTE="fwiffo, post: 223127, member: 20829"] Hello, as I have the same problem, but also I have a RS232 to TTL interface, I connected that interface and as I can see there is a block error on the NAND, the printer works correctly (only with USB interface), but won't boot the UI: **Start Init** Run Boot : Azalea GUI (C3N) V2.10 11-21-2013 Model: Azalea GUI (Chorus3N) DRAM : 256 MB [NAND] Flash Boot Large size NAND Flash memory 2048 Bytes/page 4 address cycle 8-bit bus tacls=3, twrph0=4, twrph1=2 NAND Device ID: 00000098 000000F1 00000080 00000015 Bad block table found at page 65472(0x07FE0000), version 0x00000001 Bad block table found at page 65408(0x07FC0000), version 0x00000001 and after that it continues to boot, but without any UI, hope it helps, because to understand where something isn't working, it's best to use a TTL interface, at least you can discriminate the error. In my case, I could change the nand or the board... [/QUOTE]
Verification
Post reply
Forums
Printer Forums
Printer Repair
How to fix Samsung Express C1860FW Laser Printer stuck on LOGO?
Top