Forums
New posts
Search forums
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Printer Forums
Printer Discussion
I need two printers.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
[QUOTE="Tom, post: 204307, member: 6168"] I have been using Epson and Canon inkjet printers for the past 13 years. The problem was the high cost of ink, but I began refilling the cartridges with bulk ink, which worked great. Alas, my Canon Pixma 6600 D died recently. I began looking into monochrome laser printers, which are now reasonably priced. In the end I decided against laser printers for a few reasons: none of them could print on card stock (thick enough for business cards). Apparently, thick card stock can;t be wrapped around the drum without issues. The laser printers I was considering were also said to be not very good at printing graphics. Then there are potential health issues due to the ultra-fine toner particles that laser printers may emit. I decided to buy an Epson Workforce WF1030 monochrome inkjet printer for about $70. While it doesn't print quite as clean as the Canon Pixma did, it prints much faster and achieves much deeper black. Also, the ink is smudge and water-resistant. Third party high volume ink cartridges are available. I am also looking into refilling, but have neither found a chip resetter nor intructions on how to reset the ink level via the printer itself. Not sure if any of this info helps you. [/QUOTE]
Verification
Post reply
Forums
Printer Forums
Printer Discussion
I need two printers.
Top