Forums
New posts
Search forums
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Printer Forums
Printer Discussion
OKI Printer dropping out
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
[QUOTE="arabgogs, post: 224100, member: 22068"] Hi All, I am wondering if anyone has any insight to an old printer on a network\domain, that keeps stopping printing. the printer is an OKI Microline 320 elite. I was advised the printer was not printing, upon attending, i found the ethernet cable jammed under a unit, luckily a 2nd cable was available (not in very good condition). i plugged this in a printer instantly started printing. a week later, same again, i had suspected the old cable i used may have been damaged, therefore replaced with a new cable. One again, cleared all documents and it started printing once again. A week later the same thing happened, stopped printing, however this time unplugging ethernet and inserting did nothing. i powered off and back on unplugged everything, did the same again including the mini hub, that the ethernet cable and the parallel port cable is plugged in to, turned everything back on. Nothing seemed to happen, until i began to open up all the sections, it began printing again. It has stopped again the next day. My question is, does this sound like the Data cable is damaged? it was also under the unit or could it be the mini hub? The printer is showing as ready when you go to print, but nothing happens. any help appreciated. Gordon [/QUOTE]
Verification
Post reply
Forums
Printer Forums
Printer Discussion
OKI Printer dropping out
Top