Forums
New posts
Search forums
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Printer Forums
Printer Repair
Printer problem with EPSON Stylus SX400
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
[QUOTE="boblalux, post: 201703, member: 4777"] Epson Stylus SX400 I bought this printer (unfortunately! Chip politics is immoral!) about 3 years ago and everything was fine until recently. The printer uses 4 cartridges – black – blue- red- yellow, and about 2 years ago I purchased on EBay, 4 refillable cartridges and installed these. I have now refilled them about 30-50 times with no problems. Recently the printing was blurred on the blue cartridge, so I tried rectifying this with numerous HEAD CLEAN’s, all to no avail. Assuming that the blue cartridge was defective, I then purchased 4 new generic cartridges and replaced the old blue with a new blue one. Exactly the same problem! Looking at the attached figure showing my print results of 4 rectangles of the 4 colours, you will see that what should be blue, is pink with some blue lines! Also the black is not quite 100%, although when I print with setting BLACK ONLY, the black result is 100% OK. QUESTION: What to do? Why is only the blue colour problematic? Are there 4 heads, one for each colour, and the blue one is unclean? Or, Or? I recently reset the counter to zero, and the charging ink now is disposed of externally. [/QUOTE]
Verification
Post reply
Forums
Printer Forums
Printer Repair
Printer problem with EPSON Stylus SX400
Top