Forums
New posts
Search forums
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Manufacturers
Xerox
Xerox Workcentre Pro 90 & c3545 communications problem
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
[QUOTE="larbac, post: 200940, member: 1159"] Hi, I will try to brake my reply into sections: PWS software - This is a service engineer tool and will be hard to find it only. Depending on the device to be used with it might require specific hardware such as serial cables and controller credentials. HDD - if the HDD was removed and will be easy to recover the orignal than this would be the best approach. Alternatevly you can contact your Xerox rep and ask for availability and pricing on new HDD. Some features will be require the use od HDD (i.e. scan to mailbox). The inexistence of a HDD might cause software errors when feature that require HDD are installed and configured on the device. These error might cause general malfuncition of the device. Error msg - This error is normally related with the controller not being well assembled. By what read I inclined to say the main cause could have been the HDD removal, which when removed could have caused other part of the device to be disconnected, my guess would be the IOT, IIT bus to the maincontroller. Worst scenario is to replace the IOT or controller. There might be an softer aproach to the problem and believe it could be a but or software error. If this case I advice that all firmware on the device should be updated and should be on the same family.... ESS, IOT all components should run under the same version... x.520.xxx... My advise is to get this device check by an Xerox engineer.. as it might be more components that might not work correctly after a hardware removal... I hope it helps [/QUOTE]
Verification
Post reply
Forums
Manufacturers
Xerox
Xerox Workcentre Pro 90 & c3545 communications problem
Top