Ip 2700 wont print "no paper"..

Discussion in 'Canon' started by Kulas, Jul 25, 2017.

  1. Kulas

    Kulas

    Joined:
    May 24, 2017
    Messages:
    6
    Likes Received:
    0
    Good Day...im berto i would like to ask anybody here, what is the sign of a bad logic board..i will admit im a newbie in printing repair business, in my new project a canon ip2700 was acting strange, because everytime i print, the paper goes halfway and stuck there for about 30sec.then the orange light flashes twice in a patern..indicating a "no paper" error if i press the cancel button the paper comes out or goes back in causing a paper jam...any suggestions and opinions are welcome..thanks a lot..
     
    Kulas, Jul 25, 2017
    #1
    1. Advertisements

  2. Kulas

    jerry quidilig

    Joined:
    Nov 29, 2017
    Messages:
    7
    Likes Received:
    0
    try to clean paper sensore. remove the case.. clean the sensore paper.. [​IMG]
     
    jerry quidilig, Nov 29, 2017
    #2
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.