Hello,
I have a Lexmark MX611de. If you scan a copy(single page) it prints one blank page(which successfully makes it to the paper tray) then pulls another piece of paper which stops midway through a print cycle. I've replaced the HVPS. I've put the machine in Invalid Engine Code and flash new firmware to it over USB successfully. The only error code I ever get is when I put it in Recovery Mode, the control panel shows "Firmware Error [900] kernel panic" and machine halts. Bad controller board????? And hello to everyone!
Thanks,
Russix
I have a Lexmark MX611de. If you scan a copy(single page) it prints one blank page(which successfully makes it to the paper tray) then pulls another piece of paper which stops midway through a print cycle. I've replaced the HVPS. I've put the machine in Invalid Engine Code and flash new firmware to it over USB successfully. The only error code I ever get is when I put it in Recovery Mode, the control panel shows "Firmware Error [900] kernel panic" and machine halts. Bad controller board????? And hello to everyone!
Thanks,
Russix