MP 2554 lower 3rd of page printing blank or very light

Discussion in 'Ricoh' started by unboundPromethius, Feb 12, 2019 at 10:07 AM.

  1. unboundPromethius

    unboundPromethius

    Joined:
    Tuesday
    Messages:
    1
    Likes Received:
    0
    I performed a PCDU rebuild on this machine. I replaced the OPC, Charge Roller, Charge cleaning roller, developer, transfer roller, filters and seals. I reset all the 3701 counters for replaced parts. I can't remember every single item included in the PM kit, but I replaced all parts in the kit. I printed the counter sheet and quality was good. 4 days later, the bottom 1/3rd of the prints are very faded. The only thing I am not sure in the PM kit is that the charge cleaning roller has a red stripe Does it matter where the red stripe goes, (is it biased? black, or white end?)? Other than that I am stuck trying to figure out what is going on.

    I removed the scanner and cleaned the glass shield, but that did not help. What am I missing?
     
    unboundPromethius, Feb 12, 2019 at 10:07 AM
    #1
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.