Hello peeps,
I am struggling to connect an ipad to an Epson et-2810 for a family member.
These devices previously were connect and in harmony however a new router / broadband provider installed and the printer will not reset.
I assume if I was able to reset, the printer would then pick up thr new IP address on start up and reconnect or be available on the ipads list of devices?
This model has not got a control lcd control panel which makes it more challenging.
I have looked on the rear of the device and there doesn't appear to be a reset button / hole to use a paperclip.
I assume it must be a certain combination of button pressing to reset?
Regards
Alexander
I am struggling to connect an ipad to an Epson et-2810 for a family member.
These devices previously were connect and in harmony however a new router / broadband provider installed and the printer will not reset.
I assume if I was able to reset, the printer would then pick up thr new IP address on start up and reconnect or be available on the ipads list of devices?
This model has not got a control lcd control panel which makes it more challenging.
I have looked on the rear of the device and there doesn't appear to be a reset button / hole to use a paperclip.
I assume it must be a certain combination of button pressing to reset?
Regards
Alexander